Little Falls is the Morrison County seat, down the Mississippi from Brainerd — river town, farm country around it, and wells under most of the homes outside the city lines. We run repair, replacement, drilling, and inspections down here every week.
Little Falls is the Morrison County seat, down the Mississippi from Brainerd — close enough that our trucks run there every week.
Little Falls calls are a mix: in-town-edge homes with standard submersibles, farm places with older deep sets, and rental houses where 'no water' means a tenant's already calling the landlord. All of them start the same way — what failed, switch, box, tank, or pump?
Most wells across the region land between 100 and 300 feet, and Little Falls ground runs glacial — sand and gravel in the river valley, heavier till on the higher ground. Your written estimate names the depth range and the per-foot rate we expect on your lot before the rig rolls.
It's a straight shot down Highway 10, so Little Falls work books like Brainerd work — real appointments, written estimates, phones answered around the clock.
Repair starts with testing, not guessing: breaker and switch, control box, tank charge — $125–$300 for a switch, $175–$500 for a control box, service call inside those numbers. If the pump down the hole is the problem, pulling the string starts near $1,000, and you'll see it in writing first.
When replacement is the right spend, it prices by depth: $450–$1,400 under 100 feet, $1,000–$2,500 at 100–300 feet, $1,500–$5,000 past 300. The working rule stands: a repair past half the cost of a new pump, on a pump past ten years, is usually money toward the new one.
A new well in Little Falls is one job with us: site visit and setbacks, the state well notification filed before the rig drills, the hole drilled and cased, the casing grouted and sealed, then pump, pressure tank, and electrical hookup. Per-foot: $28–$50 in sand and gravel, $40–$60 in mixed glacial ground, $50–$65 in bedrock, plus a $2,500–$5,500 completion package — the full picture is on our well drilling cost page.
Little Falls drilling leans practical: wells for new homes on the edge of town, farm wells, and old wells that have started pumping sand. We'll test an old well honestly before quoting a new one — sometimes the fix is a pump and a screen, not a hole.
Pressure tanks run $400–$2,500 installed by size, and short-cycling is the first thing we check on any Little Falls pump complaint. Selling? A well inspection runs $250–$550, well and septic on one visit $400–$650, lab panels available — written report for the lender.
Tell us what the water's doing and whether it's your home, a rental, or a farm place. The answer changes the urgency, not the honesty.
We test at the well on a booked day — estimates are written standing there.
Written estimate first: price, scope, timing. Nothing starts on a verbal okay.
Repairs usually finish the same visit. Drilling runs on the 4–8 week schedule we gave you, and we call if it shifts.
Water run clear, pressure checked, paperwork in hand — invoice, or the inspection report.
We work the towns around Little Falls, too. Near Pillager? Read about well drilling in Pillager. Or if you're closer to Brainerd, see well pump repair in Brainerd.
Drilled a new 200-foot well through mixed glacial ground for a cabin becoming a year-round home, and completed it with pump, pressure tank, electrical hookup, and permit.
“We bought the cabin to retire to, and the old shallow well couldn't keep up. They walked us through the cost before the rig ever showed up — 200 feet, what the ground would be like — and the final bill matched the written estimate.”
Final price: $13,400 · 3 days on site.
Well trouble in Little Falls, or planning a new well? Call (612) 260-8779 — we answer around the clock — or send the form and we'll call you back.