Pillager is the small Cass County town on the west door of the lakes area — farms, in-town homes, and lake places up the Crow Wing River, all on wells. We handle both ends of those wells' lives: the repair call and the new hole.
Pillager sits in Cass County on the west side of the lakes area — the wells here serve farms, in-town homes, and lake places alike.
Pillager repair calls are working-people calls: the water quit and there's stock to water, or a house full of kids and no shower. The failures are the usual four — switch, control box, waterlogged tank, or the pump itself — and the common parts ride on the truck.
Regionally, most wells land between 100 and 300 feet; Pillager-area wells follow the ground — shallower sand sets near the river, deeper glacial wells on the higher farms. Your written estimate names the depth range we expect on your place before the rig rolls.
Pillager is a short run west of Brainerd — inside our regular week. Estimates are free, written, and done in person; phones are answered around the clock.
We test the cheap parts first, every time: switch ($125–$300), control box ($175–$500), and the tank's air charge, with the service call inside those numbers. Pulling a pump starts near $1,000 — if that's where the tests point, you'll see the number in writing before anything comes out of the hole.
Replacement prices by depth: $450–$1,400 under 100 feet, $1,000–$2,500 at 100–300 feet, $1,500–$5,000 past 300. Farm places get a pump sized for the house and the yard together; lake places get one honest conversation about how much house the well serves now.
A new well in Pillager is one job with us: site visit and setbacks, the state well notification filed before the rig drills, the hole drilled and cased, the casing grouted and sealed, then pump, tank, and electrical to complete it. Per-foot rates run $28–$50 in sand and gravel, $40–$60 in mixed glacial ground, $50–$65 in bedrock, plus a $2,500–$5,500 completion package — the full picture is on our well drilling cost page.
Pillager drilling is new homes, farm wells, and lake places outgrowing shallow points. If your old well still makes good water, we'll tell you to keep it and spend the money on the pump — a new hole is the last resort, not the first quote.
Pressure tanks run $400–$2,500 by size installed, set to match your switch. Selling a place in Pillager? A well inspection runs $250–$550, well and septic together $400–$650 on one visit, lab panels available — and a written report for the lender.
Tell us what's happening with the water and what's depending on it — house, stock, or both.
We come out and test at the well head; the estimate is written there, not back at a desk.
Price, scope, and timing in writing before any work starts.
Most repairs finish the same visit. Drilling runs 4–8 weeks first call to water on, on the schedule we gave you.
We run the water clear, check pressure, and leave you the paperwork.
We work the towns around Pillager, too. Near Little Falls? Read about well drilling in Little Falls. Or if you're closer to Baxter, see well drilling in Baxter.
Pulled a dead submersible pump set at about 180 feet and set a new one with fresh wire and drop pipe. Water was off when we got there and back on the same day.
“Woke up to no water on a Saturday and figured the whole weekend was shot. They had the old pump out by late morning and the new one in by supper. The price they wrote down in the morning is the price we paid.”
Final price: $1,850 · 1 day on site.
Well trouble in Pillager, or planning a new well? Call (612) 260-8779 — we answer around the clock — or send the form and we'll call you back.